The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Still MS310

Author
Double RR
New Member
  • Total Posts : 1
  • Scores: 0
  • Reward points: 0
  • Joined: 2020/10/01 15:17:55
  • Status: offline
2020/10/01 15:24:38 (permalink)
0

Still MS310

I have a MS310 with a 3/8 sprocket..it’s been ran with a .325 20” bar # 3003 005 6821. With what chain would this of even been possible??

2 Replies Related Threads

    Roy
    Moderator
    • Total Posts : 1294
    • Scores: 19
    • Reward points: 1
    • Joined: 2016/07/27 22:51:23
    • Location: British Columbia
    • Status: offline
    Re: Still MS310 2020/10/01 21:53:04 (permalink)
    0
    It is a Rollomatic bar, somebody changed the tip.
    AVB
    Super Member
    • Total Posts : 1920
    • Scores: 81
    • Reward points: 0
    • Joined: 2017/06/21 16:35:48
    • Location: Elora, TN
    • Status: offline
    Re: Still MS310 2020/10/02 07:34:15 (permalink)
    0
    Double RR
    I have a MS310 with a 3/8 sprocket..it’s been ran with a .325 20” bar # 3003 005 6821. With what chain would this of even been possible??

    It is not possible if they want it to work properly. IF the BNC is good then change out the sprocket. The US version of the .325 sprocket is listed as being an eight tooth setup but there is also a seven tooth available but don't know if it is easily obtainable.
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC