The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Hot!HI: Anyone,,,Everyone

Page: < 12 Showing page 2 of 2
Author
Mikel1
Moderator
  • Total Posts : 669
  • Scores: 31
  • Reward points: 1
  • Joined: 2016/04/14 18:48:53
  • Location: Georgia
  • Status: offline
Re: HI: Anyone,,,Everyone 2017/07/10 17:17:00 (permalink)
0
Testing Fuel Solenoid

Attached Image(s)

Dinnie
Junior Member
  • Total Posts : 22
  • Scores: 0
  • Reward points: 0
  • Joined: 2017/03/23 12:06:29
  • Status: offline
Re: HI: Anyone,,,Everyone 2017/07/12 12:08:08 (permalink)
0
Thanks for the reply. Your picture shows a different carb fuel supply. Unless I am looking at the wrong thing. I am looking under the carb, where the gas filter is housed. There is a metal bowl under the filter gas housing, at the bottom of that bowl look like another cap,  I believe is the solenoid, that has two wires attached it. I believe each wire runs back to each spark plug.  MY John Deere is the 406777-0128-B1, I believe the ending part of the model # is B1 not E1. As I stated before it fires up and run a short while, just only from the gas I pour down in under the gas filter.  If this is the solenoid, how do I test it,,, di I need a plug/solenoid tester, and where do you purchase one?????? 
Mikel1
Moderator
  • Total Posts : 669
  • Scores: 31
  • Reward points: 1
  • Joined: 2016/04/14 18:48:53
  • Location: Georgia
  • Status: offline
Re: HI: Anyone,,,Everyone 2017/07/13 00:29:43 (permalink)
0
Any of these look like yours on link below
http://outdoorpowerinfo.c..._intek_v-twin_carb.asp

Might want to take a picture of your briggs model plate because I only see the E1.
Page: < 12 Showing page 2 of 2
Jump to:
Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC