The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Husquvarna 350 Chainsaw - where does pin go?

Author
Greg773
New Member
  • Total Posts : 3
  • Scores: 0
  • Reward points: 0
  • Joined: 2016/02/19 13:13:55
  • Status: offline
2016/02/19 14:10:24 (permalink)
0

Husquvarna 350 Chainsaw - where does pin go?

I took off the side cover (that has the pull rope on it) off my 2005 Husquvarna 350 chainsaw to clean under it.  During cleaning I noticed a pin fell out and I don't know where it goes.  The pin is 1-1/8 inches long, about 1/8 inch in diameter, and has three about 3/8 inch shallow groves running length-wise in the middle of the pin.  Anyone have any idea where this goes?  I've searched the parts diagrams and cannot find it.  Thanks!

1 Reply Related Threads

    Greg773
    New Member
    • Total Posts : 3
    • Scores: 0
    • Reward points: 0
    • Joined: 2016/02/19 13:13:55
    • Status: offline
    Re: Husquvarna 350 Chainsaw - where does pin go? 2016/02/19 16:12:55 (permalink)
    0
    I think I may have found out where it goes.  There is a hole it fits in near the upper right case screw hole.  It goes about half way into the hole.  It appears the part sticking out of the hole limits the amount the rear handle can move.  Can anyone confirm this is correct?
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC