The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Husqvarna 42 ' Rider

Author
regwal
New Member
  • Total Posts : 3
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/04/20 16:13:19
  • Location: SE Ga
  • Status: offline
2019/04/20 16:21:04 (permalink)
0

Husqvarna 42 ' Rider

42" RIDER 15hp pto clutch removal.  Mower belt jumped pully and wedged.  Can't turn engine.  Do I just unbolt and slide clutch and pully off together?
post edited by regwal - 2019/04/21 19:13:30

2 Replies Related Threads

    regwal
    New Member
    • Total Posts : 3
    • Scores: 0
    • Reward points: 0
    • Joined: 2019/04/20 16:13:19
    • Location: SE Ga
    • Status: offline
    Re: Husquavana 42 ' Rider 2019/04/20 21:01:31 (permalink)
    0
    I figured it out after lifting mower for a better look.  Never saw this problem before and not sure at this point I can remove the belt from where it is wedged.  I'll get back on it Monday afternoon with maybe a picture.  Had to cut belt on each side of clutch to remove and that might have been the easy part!
     
    regwal
    New Member
    • Total Posts : 3
    • Scores: 0
    • Reward points: 0
    • Joined: 2019/04/20 16:13:19
    • Location: SE Ga
    • Status: offline
    Re: Husquavana 42 ' Rider 2019/04/22 18:08:18 (permalink)
    0
    All is complete and everything is fine.  I wanted to post a photo but getting off PC and onto forum was just too involved.  I just hope the clutch wasn't damaged through all this.
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC