The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Hot!Trouble Removing Auger Belt

Author
ARB63
New Member
  • Total Posts : 1
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/04/21 14:51:36
  • Status: offline
2019/04/21 15:03:55 (permalink)
0

Trouble Removing Auger Belt

Hi all,
 
I attempted to replace the auger belt on my Snapper/Simplicity model I75246E, and was unable to remove the old belt...  There is a small space between the drive shaft and the auger pulley, but it is only about half the thickness of the belt--and that's after I'm pulling up on the drive pulley to increase the space as much as I can!
 
There must be a trick to this but I can't figure out what it is...  Can anyone help?
 
Thanks!

0 Replies Related Threads

    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC