The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Cam shaft gasket for Ryobi 309962012

Author
Carl hultin
New Member
  • Total Posts : 3
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/09/13 21:42:21
  • Status: offline
2019/09/13 21:46:19 (permalink)
0

Cam shaft gasket for Ryobi 309962012

I have a ryobi RY 34006 power head 30 cc 4 cycle that has a failed cam shaft seal. I can’t find a source or part number. This is the front (drive) side.

3 Replies Related Threads

    Carl hultin
    New Member
    • Total Posts : 3
    • Scores: 0
    • Reward points: 0
    • Joined: 2019/09/13 21:42:21
    • Status: offline
    Re: Cam shaft gasket for Ryobi 309962012 2019/09/25 20:38:21 (permalink)
    0
    I was able to find the following on the side of the seal. TC 5 8 16 22 OBM. This crosses to a double lip seal 5 mm thick, ID 8 mm and OD 16 mm, this is a common seal and was only 4.50 cents. Works perfectly.
    Roy
    Moderator
    • Total Posts : 870
    • Scores: 13
    • Reward points: 1
    • Joined: 2016/07/27 22:51:23
    • Location: British Columbia
    • Status: offline
    Re: Cam shaft gasket for Ryobi 309962012 2019/09/27 18:13:51 (permalink)
    0
    Good to know. Ryobi does not supply service parts for the engine block, short block only.
    Carl hultin
    New Member
    • Total Posts : 3
    • Scores: 0
    • Reward points: 0
    • Joined: 2019/09/13 21:42:21
    • Status: offline
    Re: Cam shaft gasket for Ryobi 309962012 2019/09/28 09:34:42 (permalink)
    0
    You just need to verify timing mark locations before you disassemble things. Once installed I ran it for45+ minutes with ni issues
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC