The Jack's Small Engines Forum - Join Our Online Community
2023/08/25 05:24:07
Rodgravling

Toro 675 GTS mower spring

Hi
New to this forum but was wondering if anyone could help.
I am based in the UK and have Toro 675 GTS mower fitted with a Briggs and Stratton engine.
When mowing Under hedge a branch caused the mower to stall by lodging just inboard of the petrol tank.
I managed to get it going again but it now runs on full revs. I found at the time on the mower deck a small spring (please see picture) which I guess must of come off when the incident happened.
Thing is I just cannot find where if at all it fits.
Can anyone help by suggesting
1 if it is from the mower and
2 If so where it fits.
Any help appreciated.
Joe
3 comments Leave a comment
SRTsFZ6
No pic's are showing .
 
The spring probably attaches to the governor arm and then to a tab  nearby The spring is pretty taught when attached.
 
You probably have no throttle control so the tension on the spring keeps the governor/carb in check..
 
 
.
2023/08/26 13:32:29
Conrad Sigona
I'm not certain this is the same motor as the one you have. It's on a Toro GTS Super Recycler and does have throttle control. You can, assuming the photo makes it into this message, easily see the spring, so you can tell if that's the one you have and where it goes. If the photo isn't visible, give me an email address and I'll send it to you directly.

URL for the photo is https://photos.app.goo.gl/WpaxKCmn8CddQxiD9
2023/08/26 17:42:56

Comments are closed.

Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
© 2025 APG vNext Trial Version 5.5