Join us now!

Username
Password
Verification
	Stay logged in

- OR -

Forgot Your Password? Forgot your Username? Haven't received registration validation E-mail?

User Control Panel Log out

Community Stats

1 day 7 days 30 days Max. View More

Birthdays

2017/05/27 15:55:49

RedHat101

Trimmer Starting Issue

I have a Bolesn BL250 Trimmer. I replaced all fuel lines, Filter, Carburator and Fresh fuel with correct Fuel/Oil Mixture. I am able to get it started only when I put a couple of drops of Gas in the combustion chamber then replace spark plug. Once the engine is hot i can start it all the time and it stays running but when it cools down i have to do the same procedure. WHat other things do I need to do in order to resolve this issue?

3 comments Leave a comment

Mikel1

Are you using the primer bulb and choke working properly?

2017/05/29 21:39:06

MdStamen

Make sure the idle is set properly. Bring it up to the point where the clutch kicks in then bring it back to where the clutch disengages. This insures the low idle is correct.
Next time when you are starting cold try to open the throttle just a hair and see what happens.

2017/10/11 18:26:09

MdStamen

I just had a almost exact problem. The plastic intake had a crack in it. When it got warm it was ok when it cooled it was a bear.
Your symptoms say it is starving gas on start. A good way to check this is to spray wd 40 on the intake while running and see if it gets better.

2017/11/14 21:12:15

- OR -

Trimmer Starting Issue

Comments are closed.