Home
»
Blog
»
Brand New PowerStroke Subaru Pressure Washer won't start 24 hours later
Brand New PowerStroke Subaru Pressure Washer won't start 24 hours later
Bought a brand new PowerStroke Subaru Pressure Washer from Costco.
I truly did read the setup and operating instructions before for use (add oil, gas, charged battery over night, connect hoses, etc). It started on the first pull. Worked as perfectly without a single problem. Tested it for a half hour cleaning concrete sidewalk on clear afternoon. Turned off engine, turned off water, release all pressure from system, stored united properly after use.
The next day the pressure washer won't even begin to start either by electric start or pull start. Acts as if there no gas or missing sparkplug. Does not even give the slightest hint that its trying to start.
- Tried with choke on start or run position
- Gas tank full
- Oil added according to directions (came with 14oz bottle of engine oil)
I am not expecting anyone to solve the problem. What I hoping somebody might know of some reason why this would happen 24 hours after 1st operation that was flawless; no hints of a problems during first use.
Suggestions or ideas. What are some likely causes.
Thanks
Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC