The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Kawasaki FH721V AS15 25 HP ENGINE

Page: < 12 Showing page 2 of 2 - Powered by APG vNext Trial
Author
Post
Essentials Only Full Version
chester330
Starting Member
  • Total Posts : 11
  • Scores: 0
  • Reward points: 0
  • Joined: 2024/01/12 13:51:58
  • Status: offline
Re: Kawasaki FH721V AS15 25 HP ENGINE 2024/01/17 18:26:32 (permalink)
0
Still trying to upload pics. Goes to 56 percent and stops.
I was told the upper bearing can be purchased at zero turn man

I took a compression test before I took it apart
Both cylinders where around 110 pounds each engine has 1122 hours on it should I change the rings also

Thanks for your help

I must be doing something wrong with the pics
Quote  #21
SRTsFZ6
Super Member
  • Total Posts : 2031
  • Scores: 74
  • Reward points: 0
  • Joined: 2018/11/18 07:20:58
  • Status: offline
Re: Kawasaki FH721V AS15 25 HP ENGINE 2024/01/18 08:33:05 (permalink)
0
The parts diagram doesn't show a separate bearing but if that's wrong, from what you've posted(movement), it should help/ fix the issue.
 
Measure the ring end gap and check for clearance #'s in the block. 
New rings, after hone, can never hurt..
 
.

Attached Image(s)


Scott
Quote  #22
Vconsig1
New Member
  • Total Posts : 2
  • Scores: 0
  • Reward points: 0
  • Joined: 2024/02/02 08:41:56
  • Status: offline
Re: Kawasaki FH721V AS15 25 HP ENGINE 2024/02/02 08:48:19 (permalink)
0
I went through this searching for crank/plane bearings. They are not available from dealer/manufacturer. I found a guy selling just the bearings, he claims they are from dealer, but when I got them they are like 1/4" shorter. I haven't installed yet. Anyone else dealt with this ?
Quote  #23
Vconsig1
New Member
  • Total Posts : 2
  • Scores: 0
  • Reward points: 0
  • Joined: 2024/02/02 08:41:56
  • Status: offline
Re: Kawasaki FH721V AS15 25 HP ENGINE 2024/02/02 08:48:19 (permalink)
0
I went through this searching for crank/plane bearings. They are not available from dealer/manufacturer. I found a guy selling just the bearings, he claims they are from dealer, but when I got them they are like 1/4" shorter. I haven't installed yet. Anyone else dealt with this ?
Quote  #24
Page: < 12 Showing page 2 of 2 - Powered by APG vNext Trial
Jump to:
Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
© 2025 APG vNext Trial Version 5.5