The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Troybilt horse

Author
Surveyor
New Member
  • Total Posts : 1
  • Scores: 0
  • Reward points: 0
  • Joined: 2025/05/23 09:17:28
  • Status: offline
2025/05/23 09:25:53 (permalink)
0

Troybilt horse

Hello, my troybilt 46” horse, Model 13AT78BT023, would not turn left, YouTube showed need replace steering shaft so replaced, replaced and still same problem, finally found it was grass accumulated in steering gear plate ,cleaned and turned ok, then after mowing few minutes the steering would not turn wheels, the bottom steering shaft screw came loose, tighten it up and again same happened, put old steering shaft back on and same problem. What have I done wrong ? I don’t understand why the screw at end of steering shaft keeps coming unscrewed, hadn’t done this before.

1 Reply Related Threads

    SRTsFZ6
    Super Member
    • Total Posts : 2185
    • Scores: 74
    • Reward points: 0
    • Joined: 2018/11/18 07:20:58
    • Status: offline
    Re: Troybilt horse 2025/05/24 09:04:29 (permalink)
    0
    First off, clean everything in the area spotless-Grass, old grease etc.
    If just one screw is coming loose, causing your issue, you can clean (brake cleaner)
    the hole and bolt, then use RED Loctite. Let it set up over night.
     
    Specifically, which part is coming loose:
     
    https://www.jackssmallengines.com/jacks-parts-lookup/manufacturer/troy-bilt/13-lawn-tractors/2019-models/13at78bt023-horse-46-auto-2019/steering 
     
     
     
     
    .

    Scott
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5