The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Need help on Briggs & Stratton 6.75 HP OHV engine electric diagram

Author
[email protected]
New Member
  • Total Posts : 2
  • Scores: 0
  • Reward points: 0
  • Joined: 2025/06/27 08:53:16
  • Status: offline
2025/06/27 11:01:17 (permalink)
0

Need help on Briggs & Stratton 6.75 HP OHV engine electric diagram

Hi, I am wondering if anyone have, electric circuit diagram for Briggs & Stratton 6.75 HP OHV engine, I couldn't find anywhere I looked. This on a generator. I have no spark coming at spark plug, replaced the spark plug, on-off rocker switch and ignition coil, still no spark. I like to verify the ignition wiring circuit, of 6.75 HP OHV. If anyone can share any info on how wiring should be connected to rocker switch to the sensor connection to coil, like to know that too. Thanks in advance for the help! - CN

3 Replies Related Threads

    SRTsFZ6
    Super Member
    • Total Posts : 2302
    • Scores: 80
    • Reward points: 0
    • Joined: 2018/11/18 07:20:58
    • Status: online
    Re: Need help on Briggs & Stratton 6.75 HP OHV engine electric diagram 2025/06/27 11:18:46 (permalink)
    0
    As we don't know the Briggs full model #, that would help tremendously..  
     
    IF it has a low oil cut off switch, usually on the side of the block, near the sump cover,
    it would have a single, thin BLACK wire going to it. 
    The switch is not unusual to go bad OR if indeed the oil is low-it'll kill spark.
    If it's there, simply un-plug it disabling it... 
     
    To check the coil (and everything else), pull off the starter cover. 
    Again, they'll be another thin black wire (not the same wire posted above)
    going to the coil, (often the back side of it).  That IS THE KILL SPARK WIRE
    when grounded. 
     
    Un-plug from the coil. Spin the engine over(cover back on), if you have spark, 
    the coil is fine. 
     
    If NO SPARK, either the coil is bad, or much less likely, a bad ground between the coil and block.
     
    Advise...
     
     
    .
     

    Scott
    [email protected]
    New Member
    • Total Posts : 2
    • Scores: 0
    • Reward points: 0
    • Joined: 2025/06/27 08:53:16
    • Status: offline
    Re: Need help on Briggs & Stratton 6.75 HP OHV engine electric diagram 2025/06/28 15:36:41 (permalink)
    0
    Hi Scott,
     
    Thank you for your reply and advice,  I will follow the steps you advised again, below are details of the engine.
     
    Brigg & Stratton
    Model Number - 120312  0145   E1
    Link to parts catalog

     
    This is on an old Troy-Bilt 3550 Generator
     
    Thank you,
    CN
    SRTsFZ6
    Super Member
    • Total Posts : 2302
    • Scores: 80
    • Reward points: 0
    • Joined: 2018/11/18 07:20:58
    • Status: online
    Re: Need help on Briggs & Stratton 6.75 HP OHV engine electric diagram 2025/06/28 18:50:10 (permalink)
    0
    I'm not seeing a low oil switch on that engine:
    https://www.jackssmallengines.com/jacks-parts-lookup/manufacturer/briggs-stratton/briggs-stratton-engine/100000-19z999-series/120300-to-120399/120312-0145-e1 
     
     
    The generators are what usually have the low oil switches, especially the larger ones..
     
    Again, disconnecting the KILL wire should give you spark back..
     
    .
    post edited by SRTsFZ6 - 2025/06/28 18:53:53

    Scott
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5