The Jack's Small Engines Forum - Join Our Online Community
Jacks Small Engines Lawn Mower & Power Equipment Forums
Reply to post

17 HP Briggs on a JD D105

Author
Post
Essentials Only Full Version
ButchV12
New Member
  • Total Posts : 2
  • Scores: 0
  • Reward points: 0
  • Joined: 2025/08/21 12:15:36
  • Status: offline
2025/08/21 12:23:23 (permalink)
0

17 HP Briggs on a JD D105

Bought this used about 4 months ago. Had a constant surge that was better at high speed than idle. Replaced all fuel lines, fuel pickup tube, filter and carb. Still doing the same and haven't really found a good video or instructions on "messing" with the governor or spring. 
 
Anyone out there point me in the right direction?
 
ButchV12
Quote  #1

3 Replies Related Threads
    SRTsFZ6
    Super Member
    • Total Posts : 2478
    • Scores: 80
    • Reward points: 0
    • Joined: 2018/11/18 07:20:58
    • Status: offline
    Re: 17 HP Briggs on a JD D105 2025/08/21 15:24:42 (permalink)
    0
    Surging is usually a lean condition...
     
    If you hold partially (1/2- 3/4) closed the choke (by hand, at the top of the carb), will the surging stop?
     
    The replacement carb, OEM or aftermarket? 
     
    Can you post the full ENGINE model #?
     
     
    .

    Scott
    Quote  #2
    ButchV12
    New Member
    • Total Posts : 2
    • Scores: 0
    • Reward points: 0
    • Joined: 2025/08/21 12:15:36
    • Status: offline
    Re: 17 HP Briggs on a JD D105 2025/08/21 15:31:55 (permalink)
    0
    Model number - 31R977 0001 G1 
     
    Ebay carb, same result as before carb swap. Gov spring looks stretched but I wanted to ask first.
     
    ButchV12
    Quote  #3
    SRTsFZ6
    Super Member
    • Total Posts : 2478
    • Scores: 80
    • Reward points: 0
    • Joined: 2018/11/18 07:20:58
    • Status: offline
    Re: 17 HP Briggs on a JD D105 2025/08/21 16:36:38 (permalink)
    0
    Tks
     
    https://www.jackssmallengines.com/jacks-parts-lookup/manufacturer/briggs-stratton/briggs-stratton-engine/200000-399999-series/31r900-to-31r999/31r977-0001-g1
     
    Check with the choke first and see if it smoothes out. 
    Likely not the governor.. 
     
    If it doesn't, you can do a re-set on the governor, advise
     
    .

    Scott
    Quote  #4
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5