Nissan GL600 Generator 
Kevin K
New Member
- Total Posts : 1
- Scores: 2
- Reward points: 0
- Joined: 2020/04/04 16:14:18
- Status: offline
Nissan GL600 Generator
  Hello, I recently inherited a Nissan GL600 portable generator that was a promotional item at Nissan dealerships in the early to mid 80s. I believe the engine was made by Honda and it has a Mikuni carburetor. This generator leaks gasoline so I'd like to replace the numerous rubber lines going to the carb. Some lines look cut and worn out. I need a diagram for where to attach the new ones. It looks like to rubber lines just vent the carb. Is there any diagrams to be had for these old generators? Thanks so much, Kevin
|
[email protected]
New Member
- Total Posts : 1
- Scores: 0
- Reward points: 0
- Joined: 2021/12/30 10:51:10
- Status: offline
Re: Nissan GL600 Generator
2021/12/30 10:59:20
(permalink)
Kevin, Were you able to locate info on Nissan gl600 gen? I too am searching for info to rebuild carb, spark plug.
|
Miller571
Junior Member
- Total Posts : 20
- Scores: 0
- Reward points: 0
- Joined: 2022/01/14 10:42:25
- Status: offline
Re: Nissan GL600 Generator
2022/01/17 14:33:47
(permalink)
Good to see this post, same here.
|
SRTsFZ6
Super Member
- Total Posts : 2306
- Scores: 80
- Reward points: 0
- Joined: 2018/11/18 07:20:58
- Status: online
Re: Nissan GL600 Generator
2022/01/17 19:05:32
(permalink)
his is supposedly the carb used on the machine: https://www.partsfish.com/oemparts/l/hpe/505ce576f870022d24bdd6ba/ex650-a-parts There is a vent line ABOVE where the fuel line goes.. There also another smaller line on the bottom of the float bowl to drain it.. The Honda carbs usually use smaller fuel lines(smaller ID), but that line can be purchased on flea Bay for cheap... The carb appears to be pretty basic.  I'd personally just remove the cover and start digging into it. Take pic's if need be, especially for linkages/governor, etc..
|
Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC