Join us now!

Username
Password
Verification
	Stay logged in

- OR -

Forgot Your Password? Forgot your Username? Haven't received registration validation E-mail?

User Control Panel Log out

Reply to post

Mark Thread UnreadFlat Reading Mode ❐

Husqvarna 2006 walk behind WH 5221 ignition issues won’t start

Author Post Essentials Only Full Version
corky5000 New Member Total Posts : 0 Reward points: 0 Joined: 2022/05/20 18:40:09 Status: offline 2022/05/20 18:49:02 (permalink) Husqvarna 2006 walk behind WH 5221 ignition issues won’t start Hey y’all, as you read in my subject line I got some problems, I’ve replaces the battery, plugs, Regulator, and coils and still no juice to the ignition switch. At one point it use to turn over for a couple seconds then die. now it does nothing. Any thoughts on what I should look at replacing next? the whole ignition set up? replace starter too? thanks in advance. Quote #1 1 Reply Related Threads
SRTsFZ6 Super Member Total Posts : 2031 Reward points: 0 Joined: 2018/11/18 07:20:58 Status: offline Re: Husqvarna 2006 walk behind WH 5221 ignition issues won’t start 2022/05/21 16:30:16 (permalink) The parts diagram doesn't show what engine is on there. Please post up what you have.. Check fuses and ALL safety switches. It's very likely a switch is open killing the machine. Check YT, there's numerous video's showing how to by pass the switch to confirm that particular switch is the issue. To check the starter alone, run a 12 volt lead to the cable side of the starter, it should turn over.. Confirm the battery is fully charged and get it LOAD TESTED. It may a surface charge but under load(cranking), it drops... Quote #2

Author

Post

Essentials Only Full Version

corky5000

New Member

Total Posts : 0
Reward points: 0
Joined: 2022/05/20 18:40:09
Status: offline

2022/05/20 18:49:02 (permalink)

Husqvarna 2006 walk behind WH 5221 ignition issues won’t start

Hey y’all, as you read in my subject line I got some problems, I’ve replaces the battery, plugs, Regulator, and coils and still no juice to the ignition switch. At one point it use to turn over for a couple seconds then die. now it does nothing. Any thoughts on what I should look at replacing next? the whole ignition set up? replace starter too? thanks in advance.

Quote #1

1 Reply Related Threads

SRTsFZ6

Super Member

Total Posts : 2031
Reward points: 0
Joined: 2018/11/18 07:20:58
Status: offline

Re: Husqvarna 2006 walk behind WH 5221 ignition issues won’t start 2022/05/21 16:30:16 (permalink)

The parts diagram doesn't show what engine is on there. Please post up what you have..

Check fuses and ALL safety switches. It's very likely a switch is open killing the machine.

Check YT, there's numerous video's showing how to by pass the switch to confirm that particular switch is the issue.

To check the starter alone, run a 12 volt lead to the cable side of the starter, it should turn over..

Confirm the battery is fully charged and get it LOAD TESTED. It may a surface charge but under load(cranking), it drops...

Quote #2

Jump to: