The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Toro 3400 Greensmaster tri flex hub

Author
Post
Essentials Only Full Version
bostonbob1958
New Member
  • Total Posts : 3
  • Scores: 0
  • Reward points: 0
  • Joined: 2023/10/25 10:08:12
  • Status: offline
2023/10/25 10:26:58 (permalink)
0

Toro 3400 Greensmaster tri flex hub

  I'm trying with no luck so far to remove the hub on a Toro 3400 Greens Master. I'm replacing the studs the hub will not come off the brake cable is off i don't have the Toro (TOR4097 Hub puller) what I'm using is a old rim with a large 2 jaw puller this thing will not budge. I've had it sprayed with a break free spray this hub has been on there for about 12 years so it is held there by a rust weld and keyway. Any help would be appreciated thank you in advance.
 
                                                                                                                               Bob
Quote  #1

2 Replies Related Threads
    SRTsFZ6
    Super Member
    • Total Posts : 2031
    • Scores: 74
    • Reward points: 0
    • Joined: 2018/11/18 07:20:58
    • Status: offline
    Re: Toro 3400 Greensmaster tri flex hub 2023/10/25 10:41:21 (permalink)
    0
    I would think putting a bit of heat, with a torch (oxy/acetylene  , used around the inner hub should help..
     
    I assumne your smacking the end of the puller when it's taught?
     
    .

    Scott
    Quote  #2
    bostonbob1958
    New Member
    • Total Posts : 3
    • Scores: 0
    • Reward points: 0
    • Joined: 2023/10/25 10:08:12
    • Status: offline
    Re: Toro 3400 Greensmaster tri flex hub 2023/10/25 19:31:28 (permalink)
    0
    Yes I've tapped it while puller is taught and I don't really like a torch on a hydraulic motor shaft.
    Quote  #3
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5