The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Torque requirement on 19.5hp briggs (model below)

Author
Post
Essentials Only Full Version
Kevinllee
New Member
  • Total Posts : 3
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/03/17 13:07:03
  • Status: offline
2019/04/11 14:23:07 (permalink)
0

Torque requirement on 19.5hp briggs (model below)

Model 31p677-0912-g5 Briggs & Stratton
I’m putting the sump (bottom case) back on and want to know the torque I’m supposed to use on the bolts? Should I just use the criss cross pattern and just tighten them tight without torque wrench?
Quote  #1

2 Replies Related Threads
    AVB
    Super Member
    • Total Posts : 2165
    • Scores: 87
    • Reward points: 0
    • Joined: 2017/06/21 16:35:48
    • Location: Elora, TN
    • Status: offline
    Re: Torque requirement on 19.5hp briggs (model below) 2019/04/11 15:09:10 (permalink)
    0
    Kevinllee
    Should I just use the criss cross pattern and just tighten them tight without torque wrench?



    If you want it to leak.
     
    220 in lbs.

    Quote  #2
    Roy
    Moderator
    • Total Posts : 1503
    • Scores: 31
    • Reward points: 1
    • Joined: 2016/07/27 22:51:23
    • Location: British Columbia
    • Status: offline
    Re: Torque requirement on 19.5hp briggs (model below) 2019/04/11 19:51:21 (permalink)
    0
    LOL. The correct torque and pattern is critical.
    Quote  #3
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5