The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Helpful ReplyIs there a suitable sub for B&S #694876

Author
Post
Essentials Only Full Version
jimsahm
New Member
  • Total Posts : 3
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/12/06 15:22:25
  • Status: offline
2019/12/06 18:59:46 (permalink)
0

Is there a suitable sub for B&S #694876

Need new carb spacer.... is there a suitable sub for this part number??  Googled all over to see if there was a Stens or other...no dice.  Anyone know of a good substitute?
 
-Jim
Quote  #1
List Solutions Only

2 Replies Related Threads
    AVB
    Super Member
    • Total Posts : 2165
    • Scores: 87
    • Reward points: 0
    • Joined: 2017/06/21 16:35:48
    • Location: Elora, TN
    • Status: offline
    Re: Is there a suitable sub for B&S #694876 2019/12/07 08:58:55 (permalink) ☄ Helpfulby jimsahm 2019/12/07 12:46:31
    0
    Since for some reason Briggs has it and the newer part both list as NLA there is none. But I did find it on eBay site as still having few of them.
     
    https://www.ebay.com/itm/Genuine-Briggs-Stratton-694876-Carburetor-Spacer-with-Gaskets/231949818005
     
    This something I need to contact Power Distributors about as it may only be available in kit now. Either way they are still needed time to time. But they are not even open until Monday. Maybe there is newer version that Briggs has supersede these two part numbers to yet.
    Quote  #2
    jimsahm
    New Member
    • Total Posts : 3
    • Scores: 0
    • Reward points: 0
    • Joined: 2019/12/06 15:22:25
    • Status: offline
    Re: Is there a suitable sub for B&S #694876 2019/12/07 12:46:18 (permalink)
    0
    AVB,  Thanks for your reply... The ones listed on eBay are a legacy ad.  They apparently sold out in Sep 2019.
     
    I am thinking I can rig something up, but really am shocked that nobody else has cracked their original bakelite part?  Mine fell off workbench and hit concrete floor while replacing head gasket, and well, now I've got a rebuilt top-end and no good way to mount carb on head!  If there is a work around or a later model part that works I would love to hear from someone.  If anyone has and un-cracked good carb spacer from a circa 2006 10HP Intek, PM me and I will gladly purchase it from you!
     
    Thanks,
    Jim
    Quote  #3
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5