The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Hustler Raptor with Kawasaki fr651v wont start

Author
Post
Essentials Only Full Version
Brucecooke212
New Member
  • Total Posts : 4
  • Scores: 0
  • Reward points: 0
  • Joined: 2018/06/24 20:01:52
  • Status: offline
2018/06/25 17:12:11 (permalink)
0

Hustler Raptor with Kawasaki fr651v wont start

I have a hustler raptor with a kawasaki fr651v, I leaned over to pick something up and the engine cut out when i triggered the safety switch in the seat,when I sat back up the engine came on and then went back out. I looked at the fuel tank and couldn't tell if it was empty or not so I put gas in it and it would not start back. It never studdered like it was running out of gas.I checked for fire to the plugs and had fire.I pulled the fuel hose off to make sure the fuel pump was pumping, and it was, then I unscrewed the bowl to check for fuel and it had plenty. I unplugged the wires on the bottom of the bowl and the lawnmower started up but it went right back out I plugged the wires back in and it acted like it wanted run again but went back out. I'm at a loss.please help
post edited by Brucecooke212 - 2018/06/25 17:41:26
Quote  #1

7 Replies Related Threads
    AVB
    Super Member
    • Total Posts : 2165
    • Scores: 87
    • Reward points: 0
    • Joined: 2017/06/21 16:35:48
    • Location: Elora, TN
    • Status: offline
    Re: Hustler Raptor with Kawasaki fr651v wont start 2018/06/25 18:23:59 (permalink)
    0
    On the Raptor the seat switch provide 12V to fuel solenoid (sometimes called an anti after fire solenoid). If the switch goes bad as you release the starter switch to run it shuts the fuel solenoid.  Try verifying that you have 12v at the fuel solenoid while the ignition is the run position and someone is in the seat. Mower doesn't need to be running for this test. IF the 12v isn't present I would suspect that the seat switch has failed.
    Quote  #2
    Brucecooke212
    New Member
    • Total Posts : 4
    • Scores: 0
    • Reward points: 0
    • Joined: 2018/06/24 20:01:52
    • Status: offline
    Re: Hustler Raptor with Kawasaki fr651v wont start 2018/06/25 19:29:37 (permalink)
    0
    I followed the instructions and had 12 volts.
    Quote  #3
    AVB
    Super Member
    • Total Posts : 2165
    • Scores: 87
    • Reward points: 0
    • Joined: 2017/06/21 16:35:48
    • Location: Elora, TN
    • Status: offline
    Re: Hustler Raptor with Kawasaki fr651v wont start 2018/06/25 21:13:48 (permalink)
    0
    I am kinda at a loss too as it does sounds like he fuel solenoid is closing causing the shut down but I actually need my hands on it as I could see something that I would trying to trouble shoot remotely.
     
    Maybe someone else wold chime in with something to check.
    Quote  #4
    Mikel1
    Moderator
    • Total Posts : 1181
    • Scores: 41
    • Reward points: 1
    • Joined: 2016/04/14 18:48:53
    • Location: Georgia
    • Status: offline
    Re: Hustler Raptor with Kawasaki fr651v wont start 2018/06/28 11:11:27 (permalink)
    0
    When it starts to go back out, will it pickup if you spray a shot of carb cleaner into carb?
    Quote  #5
    Brucecooke212
    New Member
    • Total Posts : 4
    • Scores: 0
    • Reward points: 0
    • Joined: 2018/06/24 20:01:52
    • Status: offline
    Re: Hustler Raptor with Kawasaki fr651v wont start 2018/06/28 12:24:48 (permalink)
    0
    No it just stalls with the solenoid plugged in or not
    Quote  #6
    AVB
    Super Member
    • Total Posts : 2165
    • Scores: 87
    • Reward points: 0
    • Joined: 2017/06/21 16:35:48
    • Location: Elora, TN
    • Status: offline
    Re: Hustler Raptor with Kawasaki fr651v wont start 2018/06/28 19:37:53 (permalink)
    1 (1)
    What Mike wanted you to try adding a little fuel down the carburetor throat as it is dying to see if it picks back up a for a little bit. Or can try temporary removing the solenoid and install a short bolt in its place; effectively disabling the fuel solenoid shut down feature. That way you know if it the carburetor that is problem or safety system shutdown.
     
    Btw the bolt is metric probably a M8-100 but not sure as I don't a Kawasaki FR651V on hand currently in the shop.
    post edited by AVB - 2018/06/28 19:38:58
    Quote  #7
    Brucecooke212
    New Member
    • Total Posts : 4
    • Scores: 0
    • Reward points: 0
    • Joined: 2018/06/24 20:01:52
    • Status: offline
    Re: Hustler Raptor with Kawasaki fr651v wont start 2018/06/28 20:53:10 (permalink)
    0
    Sorry I was short with my answer I did try carburetor cleaner and I did put some gas down at throat of the carburetor the plugs are not fouled right now I just give it a little bit of gas
    post edited by Brucecooke212 - 2018/06/29 16:58:56
    Quote  #8
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5