The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Fabricated Deck

Author
smoker
New Member
  • Total Posts : 1
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/09/05 15:42:34
  • Status: offline
2019/09/05 15:58:09 (permalink)
0

Fabricated Deck

I have a Husqvarna GTH26V52LS with the dreaded fabricated deck. It always leaves a strip of uncut grass from the center blade. I have tried every blade on the market with the same result. I have talk to Husqvarna many times with no luck. They know that those decks have the issue but have no solution to the irritating problem. Does anybody have a solution for fixing the poor cut qualities of these decks? So tired of cutting my grass twice.

2 Replies Related Threads

    Eye in the sky
    New Member
    • Total Posts : 4
    • Scores: 0
    • Reward points: 0
    • Joined: 2019/04/03 21:24:44
    • Status: offline
    Re: Fabricated Deck 2019/09/05 16:13:48 (permalink)
    0
    smoker
    I have a Husqvarna GTH26V52LS with the dreaded fabricated deck. It always leaves a strip of uncut grass from the center blade. I have tried every blade on the market with the same result. I have talk to Husqvarna many times with no luck. They know that those decks have the issue but have no solution to the irritating problem. Does anybody have a solution for fixing the poor cut qualities of these decks? So tired of cutting my grass twice.




    Would it be possible to get a large washer and try shimming the blade lower on the spindle? If it is missing the grass would assume the blade is too high. Larger washer and maybe longer bolts only a few bucks.
    AVB
    Super Member
    • Total Posts : 2165
    • Scores: 87
    • Reward points: 0
    • Joined: 2017/06/21 16:35:48
    • Location: Elora, TN
    • Status: offline
    Re: Fabricated Deck 2019/09/05 16:21:45 (permalink)
    0
    Eye in the sky
    Would it be possible to get a large washer and try shimming the blade lower on the spindle? If it is missing the grass would assume the blade is too high. Larger washer and maybe longer bolts only a few bucks.

    Not possible due to 5 point star on the spindle shaft. The only way to lower the blade would to shim the complete spindle assembly.
     
    But I have a question about the leaving is the complete width of the blade, offset to one side, or otherwise?
     
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5