The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Hot!briggs and stratton 5 hp Model # 128M05-5468-F1 will not start

Author
Post
Essentials Only Full Version
wayne64li
New Member
  • Total Posts : 4
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/10/31 21:30:30
  • Status: offline
2019/10/31 21:55:25 (permalink)
0

briggs and stratton 5 hp Model # 128M05-5468-F1 will not start

Mower will not start. it did work last week. I did the following
new carb
new coil (magneto armature)
checked flywheel pin
new spark plug
mower has spark, 70 psi compression and holding. Even though the carb is new i sprayed staring fluid in carb. i also put in new gas. i took off the head. valves seem to be opening and closing. piston looks fine
Help!!!!!!!
 
 
Quote  #1

3 Replies Related Threads
    wayne64li
    New Member
    • Total Posts : 4
    • Scores: 0
    • Reward points: 0
    • Joined: 2019/10/31 21:30:30
    • Status: offline
    Re: briggs and stratton 5 hp Model # 128M05-5468-F1 will not start 2019/11/02 18:11:28 (permalink)
    0
    I found the problem
    I noticed that on the power stroke the exhaust valve was opening. Right there, timing is off. This mower has a plastic gear on the cam.  The gear moved on the metal shaft throwing the timing of the piston and valves out of sync.
    Nobody responded so i guess im just talking to myself.  lol


    Quote  #2
    Roy
    Moderator
    • Total Posts : 1086
    • Scores: 19
    • Reward points: 1
    • Joined: 2016/07/27 22:51:23
    • Location: British Columbia
    • Status: offline
    Re: briggs and stratton 5 hp Model # 128M05-5468-F1 will not start 2019/11/02 21:15:28 (permalink)
    0
    That is a good one, I have not seen that happen. Easy enough to check but who would think to?
    Quote  #3
    AVB
    Super Member
    • Total Posts : 1705
    • Scores: 65
    • Reward points: 0
    • Joined: 2017/06/21 16:35:48
    • Location: Elora, TN
    • Status: offline
    Re: briggs and stratton 5 hp Model # 128M05-5468-F1 will not start 2019/11/03 06:36:48 (permalink)
    0
    Not totally out of the possibility but I would thought the ACR would had been the failure since it is on the exhaust side of this engine. I have seen multiple of these ACRs to fail and be mangled pretty bad causing the exhaust to open at TDC compression.
    Quote  #4
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC