The Jack's Small Engines Forum - Join Our Online Community
Reply to post

Helpful ReplyB&S 110P05-0002-F4 carb spring connection locations

Author
Post
Essentials Only Full Version
sirdeeker
New Member
  • Total Posts : 3
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/11/06 19:09:52
  • Status: offline
2019/11/06 19:30:43 (permalink)
0

B&S 110P05-0002-F4 carb spring connection locations

I have a lawn mower (Sears and Husqvarna AWD) that uses the Briggs and Stratton 110P05-0002-F4 engine. The mower does not have a throttle by design and it was running slow.  When I checked the mower, a spring fell out so I looked up in the manual. The manual part number for the spring shoes part number 209 just floating in space, not connected to anything.  I've attached a couple photos.  The linkages appear to be intact but the governor rod (part # 202 on the diagram) moves freely so it's clear that needs to be attached in some way to a spring.  My guess is the end of the governor cable get connected to the thottle and the throttle lever is connected to a spring which is connected to the vertical metal (gold colored) support.
 
Ideally this would have been shown on the diagram.
 
Thank you for you help!

Attached Image(s)

Quote  #1
List Solutions Only

2 Replies Related Threads
    sirdeeker
    New Member
    • Total Posts : 3
    • Scores: 0
    • Reward points: 0
    • Joined: 2019/11/06 19:09:52
    • Status: offline
    Re: B&S 110P05-0002-F4 carb spring connection locations 2019/11/06 21:23:10 (permalink)
    0
    I removed the air cleaner to get a clear view and added some comments to help the discussion of where to connect both end of spring number 209 in the B&S engine manual. See the attached.
     
    Thank you for your help! 

    Attachment(s)

    sears awd mower ca..inkage top view.pdf (406.87 KB) - downloaded 132 times
    Quote  #2
    sirdeeker
    New Member
    • Total Posts : 3
    • Scores: 0
    • Reward points: 0
    • Joined: 2019/11/06 19:09:52
    • Status: offline
    Re: B&S 110P05-0002-F4 carb spring connection locations 2019/11/09 19:11:10 (permalink) ☄ Helpfulby Carl Ellis 2020/01/05 21:19:59
    0
    Solved, I cleaned off the carb assembly with choke cleaner, and watched a couple videos how carbs and governors worked. None was exactly like this but it was clear the governor rod needed spring tension. After cleaning off I could see a small hole in the the throttle adjustment right next to where the governor rod attached. In the previous photo that hole was directly under the auto choke adjustment rod.  I've attached a couple of updated photos and corrected the marked up drawing to be more clear where the springs and linkages are on the sears AWD 917.375922 mower with the B&S 111P05-0002 engine.
     
    I hope you don't have the problem but if you do this should help!

    Attached Image(s)

    Attachment(s)

    sears awd mower ca...pring top view.pdf (812.01 KB) - downloaded 114 times
    Quote  #3
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5