The Jack's Small Engines Forum - Join Our Online Community
Reply to post

TORO single stage lower belt cover metal wearing away

Author
aakjaa
New Member
  • Total Posts : 2
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/12/08 22:44:55
  • Status: offline
2019/12/08 23:15:57 (permalink)
0

TORO single stage lower belt cover metal wearing away

As per pictures, anyone have suggestions to fix this?
I'm guessing the scraper was allowed to wear down too much thusly removing the metal, but only on the belt side.  The other side is just fine.  
Thinking about a thin piece of flat or rounded bar-but then I'm concerned it could raise the chassis/scraper higher than the paddles will reach?
 
any thoughts??
 
ray

Attached Image(s)

1 Reply Related Threads

    Roy
    Moderator
    • Total Posts : 1503
    • Scores: 31
    • Reward points: 1
    • Joined: 2016/07/27 22:51:23
    • Location: British Columbia
    • Status: offline
    Re: TORO single stage lower belt cover metal wearing away 2019/12/09 00:22:57 (permalink)
    0
    Welcome aboard!! I have seen that problem frequently but am not a fabricator, maybe someone else can chime in.
    Jump to:
    Copyright © 1994 - 2016 Jacks Small Engine & Generator Service, LLC
    © 2025 APG vNext Trial Version 5.5