Hello all, I am new here. Topic is a Snowblower model 922003. I am trying to find a diagram for the metal assembly that goes over the carb and contains the throttle cable, kill wire tab and governor arm. The linkage circled in the picture has a U shape and I am trying to understand if that's by design. Or if someone before me did that.

Can you post the ENGINE MODEL #?
 
Off hand, I've never seen a linkage like that.  
 
.

Yes sir! HS50-67008 (22850). See attached pic.

Ah, an old Tecumseh engine!!
 
That linkage is not OEM. 
 
Look at the pic, "engine pic #3" here:
https://jackssmallengines.com/jacks-parts-lookup/manufacturer/tecumseh/4-cycle-horizontal/hs-50/hs50-67008/engine-parts-list-3       That should help.
 
 
The entire engine:
https://jackssmallengines.com/jacks-parts-lookup/manufacturer/tecumseh/4-cycle-horizontal/hs-50/hs50-67008/engine-parts-list-2 
 
.

Thank you. Yes I have seen this diagram however it is different than what I have in terms of the carb setup and the governor linkages. I have a very different choke, and an arm with linkages on the speed control assembly (part 203A). I attached a pic where I was tinkering with a straighten out linkage, but that just greatly moves the arm into where the carb bowl would normally sit. Obviously not right either.