Still trying to upload pics. Goes to 56 percent and stops.
I was told the upper bearing can be purchased at zero turn man

I took a compression test before I took it apart
Both cylinders where around 110 pounds each engine has 1122 hours on it should I change the rings also

Thanks for your help

I must be doing something wrong with the pics

The parts diagram doesn't show a separate bearing but if that's wrong, from what you've posted(movement), it should help/ fix the issue.
 
Measure the ring end gap and check for clearance #'s in the block. 
New rings, after hone, can never hurt..
 
.

I went through this searching for crank/plane bearings. They are not available from dealer/manufacturer. I found a guy selling just the bearings, he claims they are from dealer, but when I got them they are like 1/4" shorter. I haven't installed yet. Anyone else dealt with this ?

I went through this searching for crank/plane bearings. They are not available from dealer/manufacturer. I found a guy selling just the bearings, he claims they are from dealer, but when I got them they are like 1/4" shorter. I haven't installed yet. Anyone else dealt with this ?