Honda Power Equipment Forum

Honda Power Equipment Forum (p.2)
Post New Thread
Regular
gooldg

es 6500 FUEL GAUGE

I am looking for a suitable replacement for the fuel tank gauge on my ES 6500. Serial number is the EA1- 112..... This is the screw in type. Part number shows discontinued by Honda. I am sure there is a suitable replacement. Any help would be appreciated. Thanks..

2024/04/23 23:37:08
StrangeTamer88

Hra 215 (gvx140) bound up, hard to pull and knocking after replacing oil pan gasket

the title kind of says it all. So I recently picked up an old hra215 for free. Cleaned the carb and it fired right up and ran like brand new (better than my 4 year old Husqvarna) only thing was the self propelled wasn't working. Come to find out the pin that held the gear to the drive shaft had come..
8
2024/03/07 19:48:34
Askababble

Honda hs50 snowblower

Ignition switch replacement..
2
2024/02/25 07:43:58
topsailbye

Honda HS50 Snowblower - Pull start Assy

can you recommend where I can purchase?..
1
2024/02/21 20:35:09
mmenezes

Reversed polarity on GX390

I have a Landmaster TW-400 UTV with Honda GX390. An idiot installed a new battery with anode on the wrong side. Another idiot (me) attached charger cables, essentially reversing polarity and left it on for several hours. Now the engine cranks but produces no spark. It’s not the spark plug or the oil..
1
2023/12/02 07:53:25
Mustang

What sets the GX690 apart from the GX630.......(60?) and other queries.

I am looking at options to re-power a skid steer (Owatonna Mustang 330). Looking at Honda GX630 and GX690. When I review the specs at the Honda site, every measurement including displacement and torque is the same, yet the GX690 is stated as providing 22.1 HP @3600 rpm and the GX630 20.8 HP @3600 rp..
2
2023/11/30 08:18:16
1930 Dodge

Compressor issue

This roll air compressor runs as quiet as a church mouse when initially started but refuses to start back up as it should once the start up switch detects that the pressure has dropped sufficiently. When it’s running I can hear air leaking, discovered air leaking back out the air intake tube, diffi..
2
2023/11/15 07:41:44
armyguns

Honda GC160A will not rev above 2500 rpm

This 5 hp engine is mounted to a MTD push type leave blower. The entire thing looks like it was rarely used and well cared for except it will not rev above 2500 rpm. The actual history of the machine is unknown. My friend bought it from another guy. When I first looked at the engine, I noted it w..
1
2023/11/13 08:04:28
tomcat75

honda eu3000is inverter generator

the eco switch is not working..

2023/09/28 12:02:27
Jpcopcar

GX390 Need help finding correct replacement rings.

Hello everyone and thanks for having me in your forum. Last year I bought a used pressure washer that had a GX 390 Honda engine. Are used the pressure washer a few times with no problem until I took it on a job that required me to get it down several flights of stairs. I assume that water got into t..
17
2023/09/26 08:16:13

1 2 3 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account