Honda Power Equipment Forum

Honda Power Equipment Forum (p.4)
Post New Thread
Regular
Rworster

Gx620 ignition spark

Have an older gx620 in which started back firing and running rough then quit and won’t start. Put spark tester between plug wire and plug, no spark. Put tester between plug wire and ground and it shows spark. Have installed new coils, plugs, and cleaned magnet. Coils are gapped at .010” flywheel key..
2
2023/04/24 19:09:32
Aubs

Honda FR500 tiller fuel smell in oil

I am prepping to work on a FR500 tiller that gets fuel in oil after running a bit.I cannot find any service manual info out there at all.I am hoping I will find a float level out of spec or a leaking float, since the tiller has a working fuel shut-off and I dont suspect the bowl is overflowing while..
12
2023/04/14 19:50:59
Rickrandall

GX 160 starts but won't rev

Hey guys. I have a GX 160 clone that will start and idle but dies as soon as it's given the slightest bit of throttle. The coil is new, the carb is new, the plug is new, and it ran fine a couple of days ago. Checked compression and it was below 50. I removed the head, reseated the valves and put..
1
2023/04/14 08:30:51
pospulsar99

Honda EU3000is - Issues with Choke stuck in CLOSED - Spring tension?

Working on a Honda EU3000is for my mother-in-law, and what I'm seeing is that if I pull the Choke knob to the CLOSED position, the choke cable will correctly pull on the choke control and close the choke... If I then start the generator and push the Choke knob in, to the OPEN position, the cable sli..
5
2023/04/12 19:19:03
cestx

Honda GX160T1 air index

Can anyone give me any hint about how bad the exhaust emissions of the aforementioned engine are? The complete engine model which I got recently with a tiller is Honda GX160T1 QMP1 GCABT-4639521. It is not certified for sale in the EU, US, Canada and Australia and I would like to compare its emissio..

2023/04/02 02:25:49
Dato

Gx50 honda carbys

G'day Just wondering if the gx35 carbys can be used on the Honda gx50s..

2023/04/01 00:23:38
briemer

GC160 Won't Turn Over

Hello friends. So I'll start with a short backstory of this engine. I purchased a pressure washer with this Honda engine for $100 and it didn't run (knew that when I bought it). The problem was no compression, turns out the exhaust valve wasn't seating all the way for some reason so I used some sea ..
1
2023/03/28 08:34:27

<< ..4 - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account