Kohler Engine Forum

Kohler Engine Forum (p.3)
Post New Thread
Regular
Macguy59

Carb on a Kohler Courage SV600

What is the set screw on the bottom left of this picture ? (low idle ?)..

2024/05/05 18:42:15
[email protected]

command pro ch20 piston rings

Bought an oversized piston kit from lil red barn. no instructions with the rings. one ring has a beveled inside edge and the other is square. Should the bevel be up or down and should it go in the top or second groove? also unsure of the end gap. im getting different ranges from different people- ca..

2024/04/27 17:36:48
BigMeatyClaws

Troy Bilt/Kohler Courage 22 Won't start -tried everything I can think of

As the title states, I'm not sure what else to try next after having the worst experience with the worst mower/engine I've ever dealt with (minimal experience). It started with the engine not being able to turn over and start, which led me down the deep rabbit hole of the decompression relea..
1
2024/04/27 16:24:27
carlasdaddy3

K161T Bolt Pattern

Where can I get the bolt pattern dimensions on the output side of a K161T engine?..

2024/04/26 15:37:15
chas55

Kohler ZT 740

Changed the oil with Kohler oil and filter, ran twice for at least 4 plus hours with no problem,600 plus hours on motor and no problems! Today started and ran for 10 minutes started knocking then seized, still full of oil! Any body have problems like this or heard of any?? My background is in small ..
1
2024/04/25 19:36:48
Henrikg

Kohler command pro20 crankcase ventilation problems

Hello!On my motor it vill blow out of the oilfilling pipe.The engine takes a lot of oil while using it.It should be vaccum here instead of blowing.Can it be a problem with the breathing filter or the reed valve?i have test the kompression in the cylinders and it shows around 11-12.Would be thankful ..
3
2024/04/05 00:49:26
Scotty Briles

CH740 kohler

I have a horizontal shaft CH740-0045 with crankcase wear. Oil leaking out front PTO shaft. Can the crankcase be sleeved?..
1
2024/03/27 13:23:58
BigRod

k341s 71232a

I have this k341s after reserching it confirms, yes it was on a miller bluestar generator welder. I am in the process of new plug, wire coil and condensor. I could possibly entertain selling? Will update after initial run. After years of sitting idle, I sprayed carb applied battery and it started lo..

2024/03/26 23:41:04
Carlos

Carb Fuel Bowl Retainer Screw -Toro Z4220

Hello, Anyone know what the part number is for for a fuel bowl retainer screw to replace the solenoid on a Toro Z4220 zero-turn? The engine is KOHLER, SV610-0211...I think. The carb is a Walbro LMK...

2024/03/20 10:30:56
mr tow 1

Hello. Is there a retro kit to change my Kohler 17 series 2-KT17 engine to another brand ?

Needing to find out if there is a retrofit kit to replace my Kohler series 2 -KT17 engine,which is very hard to find...

2024/03/13 08:57:46

1 2 3 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account