Snapper Forum

Snapper Forum
Post New Thread
Regular
Ironbird

Snapper HZS18482BVE 48" 18 HP ZTR -blades won't engage

Hello-My Snapper HZS18482BVE 48" 18 HP ZTR won't engage the blades when I turn on the PTO switch.I replaced the PTO switch and still have the issue. The belts and and pulleys all look good. Could the blade brakes be stuck? Thanks for any advice you can give :) -=Ironbird=-..
2
2025/04/16 13:21:08
Deerhunter5

Snapper SZ2042 zero turn

I have a snapper sz2042 zero turn and I’m having steering issues. It will only turn right. It will turn left but only at low speeds. How do I fix this. I’ve looked and I can’t find anything online that says how to adjust it. Thanks..
1
2025/04/13 15:10:30
Hatch111

1980s snapperLt 11 front engine.

Hi im looking for a diagram for where thr springs for the belt go on a 33 inch deck.Thanks..
4
2024/09/06 19:53:58
Rtibb

No power - spitting and sputtering

I have a SNAPPER series 5. It will start but has no power and runs very rough. I have replaced spark plug, gas and air filter. I have also replaced the carborator, drained and added new gas. Drained and added new oil. When the work was completed mower ran fine for about an hour, then it stalled and ..
9
2024/07/06 15:43:49
bourmb

Snapper anti-scalp bracket location dimension needed

I bought a nearly new 2020 3315525BVE this week and I really miss that Snapper didn’t include gage/anti-scalp wheels on the deck like my 2007 331723BVE. In going to order the three gage wheels and drill the holes in the deck and install. Can somebody with a Snapper that came with gage wheels from th..

2024/05/17 22:25:31
piper cub

Help with swapping engine on my 30" rear engine Snapper

I have a 20 year old Snapper mower. I'm replacing the old ( it is locked up) 10HP B&S with a new 10HP B&S. The problem is that I can't get the disc/pulley assembly off the old crankshaft. This is the one piece design. I have removed the 2 allen screws, applied Liquid Wrench, and I have heate..
1
2023/11/17 14:05:50
piper cub

Snapper rear bagger....Burnt wiring harness

I posted this in the general mower section, with no replies. I have a 10 HP rear engine Snapper that has a burnt wiring harness. Let me try to explain. Down near the oil dipstick tube, there is a white plastic fitting, with 1 wire in ( i think) and 2 wires out. Red wire, white wire, and black wire. ..

2023/08/13 07:02:08

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account