Let's Talk Shop - General Discussion

Let's Talk Shop - General Discussion (p.2)
Post New Thread
Regular
LowOil

American Made

Me and my father run a small supply and repair shop, been in business for over 15 years. Wondering if there are any American made brands for hand helds and walk behinds, real Made in America stuff not made in China "assembled in America with global parts"..

2024/10/03 21:32:23
Thesmallenginehobbyist76

Boat motor

I am wanting to convert a mower engine to a boat motor. were could i get parts?..
1
2024/09/26 16:44:02
ernver1

Northstar 13000 watt gen 165606af

looking for the ohm and volt chart for brushes, l1,l2.r1,and r2 terminals...
1
2024/09/13 15:10:39
robvreeland19

newbie question

I have a Troy Bilt TB6042XP (model) 41ADZ4PC066 4 stroke 25cc string trimmer that is 12 years old. I know it has had the wrong oil put in it at least once (for a 2 stroke). It leaks oil, even when laying flat. I am a very proficient DIYer, extensive electrical, plumbing, carpentry experience, but m..

2024/07/16 12:03:11
smaples74

New here and have a question.

I am searching for a manual or parts list for a tiller. The only Identification information is its a Mono Model # CD-50 and Serial # 84-3712. Does anyone know who made this? I know it was made in Springfield MO, but can find any info on it. Thanks..

2024/07/14 18:43:00
snapperC

snapper rer yoke

Hi, new to this...Im fixing my snapper rer sr1030 yoke. it loses drive when turning. noticed slot in yoke very worn. going to weld new pc in want to know gap? also everything is good other than axle/tires seem sloppy. watched you tube dont say much on fix.. Thnks in advance any info Cheers eh...
1
2024/06/02 17:05:25
Jag63

Primer bulb

I have a Toro TB 225 tiller with all new parts but won’t prime. Any thoughts?..
1
2024/05/26 16:16:48
boxer

New here. I have a 8 hp Brigs horizontal engine apart

Governor blew up? what holds cap on governor shaft?..
1
2024/05/25 07:41:41
Jadd

Free Mower

I picked up a free mower the other day. I was able to get it running but if I replace all the wheels like I think it needs I'd break even at best. Is asking $50 for a push mower with 4 wobbly wheels worth it or are there other ideas on what to do with a small engine?..

2024/05/03 18:58:03
Kneehouse

Chainsaw compression

I have a Husqvarna 455 chainsaw that won't start. I have good spark and fuel. The compression is only at 60 psi, it should be around 120 psi. What would cause the compression not go over 60 psi? I clean the compression relief button and it still remains too low to start. Anyone have any thoughts?..
3
2024/04/25 15:59:06

1 2 3 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account