Chainsaw Forum

Chainsaw Forum
Post New Thread
Regular
mwsjgb

Ignitiion Coil / Module for Poulan 3000 - Part # 530039128

Trying to find a replacement coil/module for this saw. Does anyone know if there is a replacement available? Everything I look at indicated the part is no longer produced. Surely there is an aftermarket replacement or something that will work?..
2
2025/04/12 15:57:49
Aerigan

Husqvarna 272xp chain brake engages while cutting

My husky 272xp chain brake continuously engages over and over while cutting or even when not cutting. Had to zip tie the handle to cut with it which I dont recommend doing. Any ideas as to how to remedy this or is a new assembly needed? Also it gives to much now when cutting. Is this the dampeners t..
15
2025/02/26 16:26:23
Thesmallenginehobbyist76

Pulan Chainsaw running out of gas

I have a pulan chainsaw that had a fuel issue after rebuilding the carb and replacing the primer bulb. It would run for 30 seconds then die, pump the primer bulb again and it would run for another 30. I then took off the primer bulb and tried to put vacuum on the end the carburetor would have vacuum..
8
2024/11/12 14:23:22
Dano41

Oppama pulse engine tachometer

Hi,trying to set carb with one of these idle is no problem but high revs it wont give me a steady reading.I have tried with and without the cable.The instructions I have mention using the mode and set buttons depending on engine type and cylinder number.Now in the instructions when you press the set..

2024/09/28 05:30:33
bhart

Homelite UT10582B chain doesn't fit

Might be a stupid question, but I have a Homelite URT10582b CHAINSAW WITH 18" bar. I bought an 18" chain and it's ridiculously too big. Much more slack than the adjustment knob can take up. What am I doing wrong?..
2
2024/06/03 18:10:08
nick890

Husqvarna 440 Chainsaw

I purchased a used 440. The saw looks near new and I took the muffler off to inspect and the piston looks near perfect. I ran compression test and it is getting 125 psi of compression. It will start, but not stay running. It seems to make a hammering noise when running. I cleaned the carb which seem..
19
2024/03/15 15:58:50
Paddy_Power

Chainsaw won't stay running

I have a proplus chainsaw (Chinese brand), I took it out the other day after it was sitting up for a few month. It fired up and ran but started to cut out when revved it up. It has gotten worse and now it will fire up but it over revs and cuts out immediately. I have changed the main fuel line as it..
3
2024/02/06 07:27:24
Marty cas

Sthil ms 251 no spark

I have a sthil ms 251 with no spark. Have replaced flywheel, coil and spark plug. Kill switch is good. Still no spark. Any ideas?..
1
2024/01/31 08:25:37
teo3

2001 Husqvarna model 345.

have to replace the fuel, fuel return and the vent. Can't find a diagram that shows any routing or pictures of the fuel tank assembly. TIA teo..
2
2023/10/16 08:15:03

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account