Latest Posts

Latest Posts (p.24)
Kohler Engine Forum
GeriatricGinger

Re: CV25S idles WOT

I would rebuild the original carb. Yeah, I might just do that this afternoon.Also, with the engine off, the governor pushes the carb throttle to wide open.Sounds like the governor is not adjusted correctly. As you noted, adjust with the throttle wide open and the governor arm also in the wide open p..

2025/06/08 07:24:23
SRTsFZ6

Re: KT745-3031 HI SPEED ADJUSTMENT

The larger engines are usually set lower to 3,400 RPM's, max RPMs 3,600.. I don't know how to answer your specific question but your going to shorten the life of your engine. I'd make sure the deck is clean, blades sharp, etc... Just my .02 ...

2025/06/08 07:12:54
Toro Forum
SRTsFZ6

Re: Toro ring deck needed

You can trace the deck (area concerned) on card board and then transfer to steel. Use a Sawzall (or similar) to trim it to shape.It would take some time but do-able. You could also bring your "template" to someone that works with metal to make one... ...

2025/06/08 07:08:43
Kohler Engine Forum
SRTsFZ6

Re: CV25S idles WOT

Excess fuel down the throat (from just sitting) indicated the float needle leaking / float leaking- definitly bad carb issues. Chinesium carbs are a crap shoot. I would rebuild the original carb. Also, with the engine off, the governor pushes the carb throttle to wide open.Sounds like the governor i..

2025/06/08 07:04:35
GeriatricGinger

Re: CV25S idles WOT

Here's the more detailed (long-winded) version, as my original post was posted on my phone.. I bought the mower with an issue of easy start, but would only idle. Any throttle input resulted in popping, stumbling, and almost flooding out.. Anything off-idle was a no-go.I noticed this had a brand new..

2025/06/08 06:34:58
SCdetector

Re: CV-16s spark advance module

I installed a CV-15 flywheel and matching coil and it works great...

2025/06/07 22:23:00
Toro Forum
[email protected]

Re: Toro ring deck needed

Thanks. I’d do it but it was literally torn off. Would need to be welded. In hind sight I should have done that and some hammering. I tossed it unfortunately. Cheers!..

2025/06/07 21:24:03
Kohler Engine Forum
GeriatricGinger

Re: CV-16s spark advance module

I don’t have a proper answer for you but my Kohler cv25 had the smart box die. I just ripped the smart crap off and installed two standard ign coils and it’s worked fine since...

2025/06/07 19:41:45
GeriatricGinger

CV25S idles WOT

I bought this Bobcat ZT (older 2005) mower with a bad carb. Replaced the carb and it worked fine for a couple mows then started puking fuel and flooding the engine. Ordered another Nikki and installed it today. Now the engine fires right up but idles at or near WOT with the throttle against the idle..
6
2025/06/08 14:03:48
Josey

KT745-3031 HI SPEED ADJUSTMENT

I can only get 3450rpms. Looking to get 3750 for more blade speed. The low IDLE speed is 1750. I changed the spring from OEM 3rd hole to #2hole to get this. Engine runs good, no surging etc. (onlyhas 250hrs).yes the governor is adjusted to spec My spring #is 24-089-50s. Online somewhere i saw that ..
1
2025/06/08 07:12:54

<< ..22 23 24 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account