Generator Forum

Generator Forum (p.2)
Post New Thread
Regular
Gotafixit

Predator 9000 problem

I have a strange problem with my Predator 9000. I have an electric start on it. The electric start works fine and the generator runs and puts out the correct AC voltage. The problem I am having with it is on the 12v circuit for the starter. When the unit is running it is producing 25 volts to the wh..

2024/12/28 12:50:53
vestaviascott

Older Generac 14KW 1800rpm with Fiat 1.6L - Overspeed shutdown - new stepper motor

Stepper motor was replaced Jan 2023. Recently unit stopped working. Starts fine but increases frequency output limit of 72hz and shuts down with solid red light. I suspected stepper motor failure so replaced it today. I replaced the stepper motor because I could not observe it moving during start..
1
2024/12/18 19:38:49
hubot

Not normal Troy Bilt

I have a Troy-Bilt/Briggs Stratton 3250/3500 generator – model # 030378 Serial # 1015494054. I believe the engine is a B&S Series 900, but the only visible markings (without removing engine from the frame) is a sticker affixed to the underside of the engine. The sticker has two barcodes. The top..
4
2024/12/13 17:21:25
Keith0910

Looking for the name of a part for MY gn-190 engine

⁰what is the name of the housing that the low pressure sensor screws into on my gn-190 6.5 horsepower..
1
2024/11/05 13:17:08
peterbilt313

Decal

I bought a Bobcat decal … I can’t get it to stick. The backing and decal stay together. I am trying to place this on my zero turn. Thanks..
1
2024/11/03 06:30:46
TimG303

Predator 8750 inverter gen AC reset problems

I have a predator 8750 Peak 7000 running watt inverter generator. It is five months old and does have a couple hundred hours on it because we use it in inclement weather to charge off grid solar batteries. I had it running a charger that uses about 3000W but I have since lowered it to 2000W and it c..

2024/10/19 12:51:17
mjc8870

Generarc RS 5500- Need help !!!!

I am looking for help in getting my Generac RS 5500 running. It only has about 6 hours on the machine. Last week I started to get ready for Hurricane Milton and attempted to start the generator.Generator was sitting for 6 monthsI attempted to start the generator, but the pull cord appeared locked, a..
9
2024/10/14 18:23:22
brownpow121

Generac 3300i won’t run off choke

Hi all. I have a generac 3300i purchased new in 2021 with about 2 hours on it. I start it a few times a year but really haven’t needed it. Recently I fired it up for a routine start but it will only run on choke. What I have done so far: -drained gas and added fresh gas -removed and completely cle..
6
2024/10/04 08:23:31
[email protected]

High voltage from DeVilbiss GBV7000

I have an old generator with a Briggs & Stratton 294447-1042-A1 engine. It's putting out 150/300v instead of 120/240. I can't find much documentation online for it (service manuals, etc), but from reading around the Internet it sounds like the engine speed controls that. Does anyone know..
1
2024/09/30 18:32:47
robertmatthews5

Discontinued Kubota part

Have a problem with my old model, though it's only done just over 700 hrs, Kubota GL6500S generator. After it's warmed up and with around 25% full load, the voltage is high at around 246 volts and for short periods, jumps to 296 volts ...its a 230 to 240 volt 50Hz unit. I pulled out the Emergency Re..

2024/09/13 21:06:26

1 2 3 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account