Small Engine Forum

Small Engine Forum (p.5)
Post New Thread
Regular
LOWRYDER

FX691V

Has any one had this engine to surge from the low range to the hi side what did you to fix..
3
2024/09/13 02:39:06
Douglas Lee

Troy-Bilt Horse riding lawn mower, Kohler engine

Hello All, I picked up an abandon Troy-Bilt Horse riding lawn mower with a Kohler Courage sv720 v-twin 23 hp engine. In an effort to get it running I did a cylinder leak down test, adjusted the valves, replaced one ignition module, changed the oil and oil filter, fresh air cleaner, fresh fuel fil..
2
2024/09/06 04:17:02
Mountaingnome

Trying to revive Subaru EA190V exhaust valve adjustment screw missing

I recently picked up an orphan Subaru EA190V pressure washer which I'm trying to save from the landfill. It had obviously been poorly maintained and had the typical old engine problems- bad gas in the tank, fuel lines rotten, rust in the carb from water sitting, dead battery.There were some signs so..
1
2024/08/26 10:56:14
[email protected]

Briggs & Stratton Excess Fuel/Oil and Choking Out

Hello! New member here. I have a Craftsman riding mower with a Briggs & Stratton 331877-1234-B1 (21.5 HP) engine. It just recently developed a severe problem out of nowhere (just happened one day when trying to start it up cold) where it is getting drenched in fuel (and possibly oil too, not sur..
16
2024/07/19 09:45:33
Teach

Honda Ht3813 riding mower

PTO CLUTCH Clutch was seized on. Mower sitting for 3 years. Pulled clutch off. Pulled apart. I had 3 steel ball bearings I took out but saw a video it should have 3?? For sure I did not lose 3. Should there be 6 or 3. Thx for helping folks...

2024/07/17 13:20:01
tchr2dy

Murray Ultra TC300 mini tiller

Hi Everyone,I am wading through my first major repair of a small engine and I have successfully, with the help of MANY videos, I've been able to put the mini tiller back together, EXCEPT for the recoil spring and rope retracting after I pull the rope in an attempt to start the unit. Once I release t..
5
2024/07/02 21:08:06
Gregj83

Engine will not start

I mounted a new Briggs and Stratton engine 104M02-0196-F1. I put in new oil and fresh gas and pulled the starter rope and it will not start. Today I changed the plug after verifying I had a spark, and it will not start. I am at a loss as to what is going on. Any suggestions appreciated this engine i..
1
2024/06/27 07:38:00
Kongaman

Removing crankshaft spacer from Craftsman/Tecumseh

Guys, I need to open up the case on an old engine (Craftsman 143.216182/Tecumseh V60-70223G) from a Craftsman 917.285260 shredder/mulcher. Trouble is, there's some kind of collar/spacer affixed to the crank and I can't figure out how to get it off so I can slide the cover over the shaft. It's got..
1
2024/06/18 07:45:10
DavidinColorado

Cub Cadet Lawn Tractor will not restart

I have a 1 year old Cub Cadet lawn tractor that will start and stay running if I start it by priming the carburetor with a little gas. Fuel filter and fuel pump seem to be working. When I stop the tractor, basically it automatically turns the engine off when I get off the seat, it will not restart. ..
2
2024/06/13 08:39:10
DavidinColorado

Cub Cadet Lawn Tractor will not restart

I have a 1 year old Cub Cadet lawn tractor that will start and stay running if I start it by priming the carburetor with a little gas. Fuel filter and fuel pump seem to be working. When I stop the tractor, basically it automatically turns the engine off when I get off the seat, it will not restart. ..
4
2024/06/12 08:56:32

<< ..4 5 6 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account